WIS Document: 4033

| | Direction indicators Fault symptom Direction indicators light continuously. Direction indicators do not light. Diagnostic procedure 1 Check the normal operation of the direction indicators Switch on the hazard flashers. Is the function correct? | yes Continue with point 2. | no Continue fault diagnosis as described in Service Manual 3:5 "Electrical system, ICE". See also fault diagnosis for diagnostic trouble code B1432, B1433 or B1442 and also checking of direction indicators and hazard flashers. 2 Check the operation of the direction indicators, using an ISAT scan tool. | - | Connect the ISAT scan tool. | - | Select "ACTIVATE". | - | Select "FLASHERS". | - | Select "ON". The direction indicators should remain on continuously. Is the function correct? | yes The fault is of intermittent nature, proceed to point 4. | no Continue with point 3. 3 Check the wiring Remove the alarm control module. Conduct a continuity test between: | - | control module pin 24 and connector, left-hand side direction indicators. | - | control module pin 12 and connector, right-hand side direction indicators | - | pins 24 and 12 of the electronic control module and a good grounding point. The resistance should be < 1 ohm. Is the resistance correct? | yes Continue with point 4. | no Repair or replace the wiring harness. 4 Final check Check to see if the fault symptom remains. Is the problem still present? | yes See "Before replacing a control module". | no The remedial measures taken were correct or the fault is of intermittent nature.