WIS Document: 5261

| | Wheel sensors, front | Removal Left side: | 1. | Open the bonnet | 2. | Unfasten the electrical distribution box and move it away. | 3. | Part the electrical connection, push in the locking catch and unfasten it from the bracket. | 4. | Cut off the cable tie on the McPherson strut. | 5. | Unfasten the level sensor connectors. | 6. | Unfasten the coolant expansion tank and move it out of the way. Right side: | 7. | Unfasten the air filter housing over part and the mass air flow sensor and move it away. | 8. | Unfasten the connector cable tie from the branch bolt. | 9. | Part the connector and cut off the cable tie. | 10. | Also cut off the cable tie at the air filter housing mounting. Jointly left and right side: | 11. | Lift the car and remove the wheel. | 12. | Clean the area round the wheel sensor using a soft wire brush. | 13. | Undo the wheel sensor retaining screw and remove the wheel sensor. | 14. | Take away the rubber grommet and thread out the conductor. | 15. | Remove the conductor from the fastening clip and lift away the wheel sensor. Part the connector. | Fitting Jointly left and right side: | 1. | Thread the cable through and push the connector onto the bracket. | 2. | Fit the wheel sensor in its holder and tighten the retaining screw. | 3. | Lubricate the rubber grommet with soapy water and install it. | 4. | Press the cables into the fastening clips. | 5. | Fit the wheel and lower the car to the floor. Right side: | 6. | Connect the connector. | 7. | Fit a new cable tie to the air filter housing mounting. | 8. | Fit the upper part of air filter housing and install the air-mass meter. Left side: | 9. | Connect the connector. | 10. | Fit a new cable tie to the McPherson strut shaft. | 11. | Fit the level sensor electrical connection and coolant expansion tank. | 12. | Replace the electrical distribution box. | 13. | Close the bonnet and erase the diagnostic trouble codes.