WIS Document: 5332
Model Context: 900 (1998)
| |
Replacing brake pipe
|
Removal
| 1. |
Clean the connections of the
damaged brake pipe.
| 2. |
Unscrew the brake pipe and any other securing clip.
| Important
|
Use a brake wrench for fitting and removing nipples.
|
| 1. |
Insert plastic plugs into the open
connections and removed the damaged brake pipe.
|
Fitting
|
|
| Warning
|
|
Brake pipes should not be bent or strained after installation.
|
| 1. |
Using compressed air, blow the
new brake pipe clean.
| 2. |
Position the pipe, remove the plastic plugs and tighten the connecting
nuts.
Tightening torque 15 Nm (11 lbf ft)
| 3. |
Bleed the brake system. See section "Bleeding the brake system".
| 4. |
Check the tightness of all brake pipe
connections.
Canonical Workshop Redirect
For step-by-step instructions, interactive illustrations, and official wiring diagrams, refer to the human-optimized workshop page below.
Switch to Interactive WIS